Broom Head Spacers

Installing these spacers will make the faceplate fit tighter to the head, and is best suited for when WCF or Standard (non-coated) fabric is used on the faceplate assembly.  These spacers should not be required when Coated fabric is used on the faceplate.

Installation Steps

There are 4 locking tabs for the faceplate on the bottom of the broom head.  Attach a spacer to each of those tabs.

IMG_5476.jpg

Cut out the 4 spacers along the dotted lines

IMG_5461.jpg
IMG_5462.jpg

Remove the backing from the spacer and align the dark bar of the spacer with the bottom edge of the broom head.

IMG_5473.jpg

Fold the remaining part of the spacer over the locking tab and into tab cavity

IMG_5474.jpg

Repeat above steps for remaining spacers and tabs